How many loopback addresses are there?ģ75 loopback addresses, but nearly every program only uses 127.0. Cut away two inches of the main sheath covering the eight wires. Cut 4 or 5 inches of the end off a network cable, keeping the connector intact. To build this particular loopback connector you will need one (1) spare Category 5e (cat5) cable. How many wires are needed in an Ethernet loopback plug? It chooses the Router ID from the IP addresses of the configured and enabled interfaces. OSPF, without a specifically defined Router ID, will pick a Router ID on its own. The loopback interface is useful because it is an interface with an IP address which never goes down.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |